IDEA

Step 1 of 5

Shown on a frame, not a hook. Ctrl+1. The pull runs on a line through the two holes. The part farthest from that line bends the most: here the back of the C, on your hook the bottom of the bowl.

Loading the video

Speed

Steps

That spot is usually red on your stress plot. Material added in the plane of the hook, away from the pull line, does far more than making the part thicker. New to this? Watch Fix it in the sketch first.

What you should seeThe front view of the part, flat on the screen.
- Guide: Run it and read the stress(opens in a new tab)

Go deeper, not thicker